Steelcase 462 Leap Plus Replacement Instructions Manual

Steelcase 462 Leap Plus Replacement Instructions Manual

Chair control replacement

Advertisement

Quick Links

®
462 Leap
Plus Chair Control Replacement Instructions
(Removal Shown - Reverse Steps for Installation)
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
or a flat-bladed
for immediate action by people who want to help you.
screwdriver that is 8"
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
or longer
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
© 2005 Steelcase Inc.
Grand Rapids, MI 49501
Page 1 of 6
U.S.A.
939546234 Rev B
Printed in U.S.A.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 462 Leap Plus and is the answer not in the manual?

Questions and answers

Summary of Contents for Steelcase 462 Leap Plus

  • Page 1 Plus Chair Control Replacement Instructions (Removal Shown - Reverse Steps for Installation) If you have a problem, question, or request, call your local dealer, or Steelcase Line 1 at 888.STEELCASE (888.783.3522) or a flat-bladed for immediate action by people who want to help you.
  • Page 2 Slide seat fully forward while holding the seat slide lever. Locate the black quick release tab located on the left hand side of the chair (as you sit in it) between the plates. Lift the quick release tab while pulling the seat slide lever and sliding the seat forward.
  • Page 3 Black and Midnight With the arm adjusted all the way up, remove the outer pod cover and arm by one of the following methods: a) For black and midnight colored chairs pull the pod cover out from the bottom thus releasing it from the inside cover and clearing the steel bracket.
  • Page 4 Unscrew two (2) front screws to remove the control cover. NOTE: After control cover screws are removed, the chair back is free to move. Hold chair back firmly to avoid possible injury. CONTROL COVER Unscrew two (2) rear screws to remove cowling. Page 4 of 6 939546234 Rev B...
  • Page 5 Pop screw covers out (7a) and remove upper pivot screws (7b). Remove lower pivot screws. Compress back frame inward off arm rivets. Remove back frame and seat carrier from chair. Remove inner arm covers. INNER ARM COVER Page 5 of 6 939546234 Rev B...
  • Page 6 Adjust chair control to maximum seat height if possible. Turn chair control upside down or on its side. Install the pneumatic cylinder removal tool (Service part 4620551SR / Part number 879100100) on the top part of the pneumatic cylinder, as close as possible to the chair control CHAIR housing.

Table of Contents