Product Mounting And Loading - Ubert Top Line User Manual

Operation
5.4.2.2 Double Spits
The pointed end of the spits can be assembled into either right or left disk.
If you are right handed it may be easier to install the pointed end of the spit into the disk on
the left as your stronger right hand will be holding the weight of the product while your left
hand positions the spit into the disk. If you are left handed the opposite may b true.
The spits must be positioned with the bend in the supports bracket toward the center as
shown below. Position the recesses in the shafts so they drop into the holes in the disk. This
will keep the spit from sliding.
5.4.2.3 Rack and Basket
Position racks or baskets into holes as shown below. Be sure recessed rings on end of shafts
drop into hole in disk as shown below.

5.5 Product mounting and loading

5.5.1 Angle spits for mounting the chickens horizontally
Insert the spit through the holes in both ends of the chicken while holding the spit angle down
and the chicken breast up. See picture below.
Tie the chicken legs to prevent flopping while grilling. Chickens can be mounted horizontally
on Model RT 405 or RT 407 Angle Spits.
When all chickens are loaded onto the spits use 2 pairs of channel lock pliers to grasp the
angle spit as shown in the picture below. The angle spits can then be loaded onto the
rotisserie disks using the pliers. Directions for operating the rotisseries and using the loading
switch are on the following pages.
Printed: 01/2018 Subject to change!
Bend in support
bracket toward
center of disk
Place basket in holes
near edge of disk
Position shaft
recess into disk
holes
Position shaft
recess into disk
holes
TopLineUserManual.docx
25