Ubert Top Line User Manual page 24

24
Note! The configuration of holes in diskes are different. Disk with two holes near
the center is assembled on the left hand side and disk with one hole near center
is assembled on the right hand side.
Tighten nuts against disks.
Holes
line up
Flat in disk
mounts on
flat shaft
5.4.2 Spit assembly into rotisserie
5.4.2.1 Angle Spit
For mounting chickens horizontally and without piercing chicken.
Mount spit into holes as shown below. Be sure recessed rings on end of shafts drop into hole
in disk.
Printed: 01/2018 Subject to change!
Flat in disk
mounts on
flat shaft
Holes
line up
Position shaft
recess into disk
holes
TopLineUserManual.docx
Operation