Component Function And Location - Ubert Top Line User Manual

22
5.2.5 Manual Operation
Turn the automatic/manual switch to MANUAL.
Turn function switch to cooking.
Load the spits.
Note! The Loading Switch or the Function Switch can be used to load spits as
outlined below.
Note! The model RT 403 – RT 405 with an electronic control is not equipped with a
Loading Switch.
Using the Loading Switch:
a. Open the door.
b. Press and hold the loading switch until the spit disk reaches the desired position and then
release the loading switch.
c. Load the spits using pliers as shown in item 5.3.1 – 5.3.3.
d. Repeat Steps b and c until all splits have been loaded and then close the door.
Using the Function Switch:
a. Open the door.
b. Turn the function switch to WARMING to rotate the spit disk to the desired position and
then turn the function switch to LOADING to stop the rotation.
c. Load the spits using pliers as shown in item 5.3.1 – 5.3.3.
d. Repeat Steps b and c until all spits have been loaded and then close the door.
e. Turn function switch to OFF.
Set the desired temperature using the temperature control.
Rotisserie will now cook until the operator turns the function swtich to WARMING, which will
keep the spits rotating and the quartz lamp will remain on.
The products can be unloaded using the same procedure as when they were loaded.
Turn the function switch to OFF to turn the rotisserie completely off.

5.3 Component Function and Location

5.3.1 Components
Shaft and disk assembly is used to mount and rotate the products.
Rotisseries are equipped with either an electronic or computer control. The operation of these
controls will be explained separately in this section.
Automatic/Manual Switch is used to place the rotisserie in either the automatic or manual mode.
MANUAL MODE:
AUTOMATIC MODE: When the rotisserie is in the automatic mode the cook time and tempe
Function Switch has 3 positions:
COOKING: cooks the product.
WARMING: Keeps the produst warm and the spits rotating or can be used to position the spit
disk for loading.
LOADING: Stops spit disk rotation for spit loading.
Temperature Control is used to set the temperature when the automatic/manual switch is in the
manual mode.
Loading switch is used to rotate the spit disk to the desired position for loading.
Printed: 01/2018 Subject to change!
When the rotisserie is in the manual mode the temperature is contolled
by the temperature control and cook time is timed by the operator.
rature are controlled by the electronic or computer control.
Operation
TopLineUserManual.docx