Ubert Top Line User Manual page 18

18
Time-Display (lower 7-segment)
Shows time / start delay at operation level.
Shows parameter data at programming level.
If no program is running and a program is selected:
Total set time of the selected program.
Push to change start delay. (
delay can be changed; push
If the PA program is selected:
Set time of the PA program
Push to change set time.(
can be changed. If the time is set to 00:00, the PA program will run endless.
Push again to change start delay.(
start delay can be changed; push
If a program is selected and running:
Remaining delay time during start delay.
Remaining total time while program is running.
Keep pushed to show the total set time of the running program
If PA program is selected and running:
Remaining delay time during start delay.
Remaining total time while running or "Endl" (for endless) in case the set time = 00:00 .
If a certain time was preset, push
pushing up/down button
Temperature Button
If a program is selected and running:
Keep pushed to show the set temperature of the current step of the selected, running
program in the Temperature-Display
If PA program is selected:
Push to change set temperature.
Up Button
At operation level:
Push to select next program.
If PA program is selected:
Push to increase settings.
At programming level:
Push to increase parameter data.
Down Button
At operation level:
Push to select preceding program.
If PA program is selected:
Printed: 01/2018 Subject to change!
11
starts to flash); by pushing up/down button
again to enter the change.
12
starts to flash); by pushing up/down button
11
starts to flash); by pushing up/down button
again to enter the change.
to change the remaining set time. (
/
the set time can be changed.
.
Operation
/
the start
/
the set time
/
12
starts to flash); by
TopLineUserManual.docx
the