Ubert Top Line User Manual page 19

Operation
Push to decrease settings.
At programming level:
Push to decrease parameter data.
Core Temperature Button
At any time:
Push to toggle between oven temperature and core temperature probe shown in the
Temperature-Display
Programming Button
At operation level:
Push for app. 5 seconds during stand-by to enter the programming level.
At programming level:
Push to enter the selected parameter data and change to the next parameter.
Start/Stop Button
At operation level:
Push during stand-by to start a program.
Push for app. 3 seconds during program run to abort the program.
Push to quit the alarm at the end of a program.
Time Button
Keep pushed to show the total set time of the selected program.
Push to change set time in PA program.
Push to change start delay.
If no program is running and a program is selected:
Push to change start delay.(
can be changed; push time button again to enter the change.
If PA program is selected:
Push to change set time.(
be changed.
Push again to change start delay.(
delay can be changed; push the time button again to enter the change.
If a program is selected and running:
Push to see the total set time of the selected program in the Time-Display
If PA program is selected and running:
Push to change the remaining set time.(
the set time can be changed.
11 Start delay LED
At operation level:
Shines while the start delay time is shown in the Time-Display
Printed: 01/2018 Subject to change!
.
11
starts to flash); by pushing up/down button
12
starts to flash); by pushing up/down button
11
starts to flash); by pushing up/down button
12
starts to flash); by pushing up/down button
/
the start delay
/
the set time can
/
the start
.
/
.
TopLineUserManual.docx
19