Ubert Top Line User Manual page 21

Operation
5.2.4 Programming the digital electronic
To enter the programming level, push and hold the Programming Button
Temperature Display
Button . Use the up/down button
Programming Button
Additional information on how to quickly adjust numbers with the up/down button
Push and hold the up/down button
Start:
After 10 steps
After 10 steps
"PROG" is shown in the Temperature Display
Programming Button
A) The Temperature Display
Use the up/down button
Programming Button
confirm your setting by pushing the Programming Button
B) The Temperature Display
Use the up/down button
Programming Button
confirm your setting by pushing the Programming Button
C) The Temperature Display
Use the up/down button
Programming Button
confirm your setting by pushing the Programming Button
Repeat A-C for the remaining programs 2 - 20.
If a program is not needed, just enter "000" for the temperature of the first step of a program. All other
steps will be skipped and the next program appears.
Once the time setting for "Pr20.3" is done, or no button is pushed for 15 seconds, the controller will
leave the programming level and go back to operating level.
In case a wrong code has been entered, "FALS" is shown in the Temperature Display
to wait for the time out (app. 15 sec.) before a code can be entered again.
Printed: 01/2018 Subject to change!
and "100" is shown in the Time Display
/ to adjust to '555' and confirm the code by pushing the
.
/
+1
+10
+100
.
now shows number and step of the first program "Pr1.1".
/ to adjust the desired temperature and confirm your setting by pushing the
. Use the up/down button
now shows number and step of the first program "Pr1.2".
/ to adjust the desired temperature and confirm your setting by pushing the
. Use the up/down button
now shows number and step of the first program "Pr1.3".
/ to adjust the desired temperature and confirm your setting by pushing the
. Use the up/down button
. Now release the Programming
to quickly move forward:
. Confirm to enter the programming level by pushing the
/ to adjust the desired time as [hh:mm] and
.
/ to adjust the desired time as [hh:mm] and
.
/ to adjust the desired time as [hh:mm] and
.
until "COdE" is shown in the
:
/
and you have
TopLineUserManual.docx
21