Bulkhead Connection - Raven TC1 Installation Manual

CHAPTER 3
FIGURE 6. Positive Bus Bar
6. Install the one power wire from the node cable on the bolt.
NOTE: It may be necessary to cut the ring terminals from the power wires and crimp new ring terminals (P/N
405-0200-052 or 405-0200-053) on the end.
7. Reinstall the machine red battery cable on the bolt.
8. Reinstall the bolt in the fuse panel.
9. Loop and tie-off the REMOTE SWITCH cable connection, securing it with plastic cable ties as necessary.

BULKHEAD CONNECTION

1. Remove machine bulkhead connector and insert round connector in the removed bulkhead location.
FIGURE 7. Bulkhead Connection
10 TC1/HDU Installation Manual for Buhler Versatile Row Crop Steer-Ready (MY2015 & Newer)