Save Configuration; Reboot System - ZyXEL Communications GS1350 Series User Manual

In the Maintenance screen, click the Click Here button next to Erase Running-Configuration to clear all
1
Switch configuration information you configured and return to the Zyxel default configuration settings.
Click OK to reset all Switch configurations to the Zyxel default configuration settings.
2
Figure 191 Erase Running-Configuration: Confirmation
In the Web Configurator, click the Save button in the top of the screen to make the changes take
3
effect. If you want to access the Switch Web Configurator again, you may need to change the IP
address of your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1).

33.2.2 Save Configuration

Click Config 1 to save the current configuration settings permanently to Configuration 1 on the Switch.
These configurations are set up according to your network environment.
Click Config 2 to save the current configuration settings permanently to Configuration 2 on the Switch.
These configurations are set up according to your network environment.
Click Custom Default to save the current configuration settings permanently to a customized default file
on the Switch.
Note: If a customized default file was not saved, clicking Custom Default loads the factory
default configuration on the Switch.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration changes
to the current configuration.
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.

33.2.3 Reboot System

Reboot System allows you to restart the Switch without physically turning the power off. It also allows you
to load configuration one (Config 1), configuration two (Config 2), a Custom Default or the factory
default configuration when you reboot. Follow the steps below to reboot the Switch.
In the Maintenance screen, click a configuration button next to Reboot System to reboot and load that
1
configuration file. The following screen displays.
Figure 192 Reboot System: Confirmation
Chapter 33 Maintenance
GS1350 Series User's Guide
259