Safety Information; General Safety Information; Construction; Mounting Method - Honeywell Centra Line HAWK 8000 Installation & Commissioning Instructions

SAFETY INFORMATION

General Safety Information

When performing any work, all instructions given by the
►
manufacturer and in particular the safety instructions
provided in these Installation and Commissioning
Instructions are to be observed. Make sure that the local
standards and regulations are observed at all times.
The HAWK 8000 System (including the HAWK 8000
►
Controller, Panel Bus I/O modules, expansion modules,
etc.) may be installed and mounted only by authorized and
trained personnel.
If the controller housing is damaged or missing,
►
immediately disconnect it from any power.
If the device is broken or defective, do not attempt to repair
►
it yourself; rather, return it to the manufacturer.
It is recommended that devices be kept at room tem-
►
perature for at least 24 hours before applying power. This
is to allow any condensation resulting from low shipping /
storage temperatures to evaporate.
The HAWK 8000 System must be installed in such a
►
manner (e.g., in a lockable cabinet) as to ensure that
uncertified persons have no access to the terminals.
If the HAWK 8000 System is modified in any way, except
►
by the manufacturer, all warranties concerning operation
and safety are invalidated.
Rules regarding electrostatic discharge should be followed.
►
Use only accessory equipment which comes from or has
►
been approved by Honeywell.

Construction

The HAWK 8000 Controller is an independently mounted
electronic control unit with fixed wiring.

Mounting Method

The HAWK 8000 Controller is suitable for mounting as
follows:
in cabinets;
►
in fuse boxes conforming with standard DIN43880, and
►
having a slot height of max. 45 mm;
in cabinet front doors;
►
on walls.
►
EN1Z-1016GE51 R0218
HAWK 8000 CONTROLLER – INSTALLATION & COMMISSIONING INSTRUCTIONS

WEEE Directive

WEEE: Waste Electrical and Electronic
Equipment Directive
At the end of the product life, dispose

of the packaging and product in an
appropriate recycling center.
 Do not dispose of the device with the
usual domestic refuse.
 Do not burn the device.

END USER LICENSE AGREEMENT

See End User License Agreement (EULA) at
www.tridium.com/en/resources/library

MODEL DESCRIPTION

HAWK 8000

DIN-mounted, 24 VAC/DC (50/60 Hz) powered, Niagara®
controller. See the HAWK 8000 – Product Data (Product
Literature No.: EN0Z-1016GE51) for complete specifications.

Included in Shipment

This package includes the following items:
▪ The HAWK 8000 Niagara® controller;
▪ A microSD flash memory card in plastic case. See section
"Preparation" on pg. 4;
▪ Coax-mounted, dual 2.4/5.8 GHz antenna for a wireless
local area network (WLAN), two 3-position RS485 con-
nector plugs, one 2-position power connector, and a
grounding wire;
▪ The HAWK 8000 Controller – Mounting Instructions
(Product Literature No.: MU1Z-1016GE51).
2
.