Advertisement
There are a number of items to do to get your system on your network and
ready to use.
Startup and shutdown
There are several procedures to turn on or off your system.
First plug in the power cord
1.
Plug the power cord into the rear of the power supply.
2.
Press the power button once. The control board initiates the power up
sequence in three seconds.
Power down
Turn off the unit using a clean operating system shutdown from Windows.
How to install the SFPs
This product uses hot-swappable SFPs, but you should disconnect any cables
before changing the SFP modules.
Caution:
Wear a grounding strap when handling SFPs to avoid
damaging them or other components. Avoid exposure to laser
radiation from optical components by keeping the dust plugs
installed until you are ready to install the cables.
♦
Your
transceivers
can be inserted into any open port and in any
order.
♦
You can hot-swap the connected transceivers at any time, but it is
recommended you then re-launch Observer Analyzer so that the
new speeds can be identified.
How to set the IP address
Setting the IP address ensures the hardware appliance has a visible and
permanent network presence.
Prerequisite(s):
♦
A
KVM
switch or keyboard, monitor, and mouse are connected.
The user input devices or KVM switch are only temporarily
needed to set the IP address, so you can disconnect them after the
IP address is set.
♦
The IP, subnet, and gateway or router addresses are available and
known to you.
1.
Log in to the Windows operating system using the Administrator
account and its default password admin.
You can change the Administrator account password after logging in.
See the Windows documentation if necessary.
2.
Select Internet Protocol Version 4 (TCP/IPv4), and click Properties.
3.
Set the IP address, subnet mask, router or gateway, and DNS server for
your environment and click OK.
4.
Click OK again to close the Properties dialog for that network
connection.
Configuring your system
4 — © 2020 Viavi Solutions (8 Apr 2020)
You interact with the hardware appliance through the Apex UI.
Navigate to https://hostname where hostname is the IP
1.
address or DNS name for the appliance.
Log into the interface using the username admin and default password
2.
admin.
Configuring the LOM or IPMI port
Your appliance comes with an on-board LOM or IPMI port that provides
you a dedicated management channel for device maintenance. It allows you
to monitor, start, stop, and manage your appliance remotely regardless of
whether the appliance is powered on.
If you want to use Lights Out Management features, you must first configure
the IP address for the IPMI port from the BIOS. Then, you should change the
administrator password to something different than the default.
1.
Connect an Ethernet cable from your router or switch to the IPMI or
LOM port.
2.
When starting your appliance, press Delete during POST to enter the
BIOS setup.
3.
In the BIOS, choose IPMI > BMC network configuration.
4.
Set Update IPMI LAN configuration to Yes.
5.
Set Configuration Address source to Static.
6.
Configure the Station IP address, Subnet mask, and Router address.
These values must be valid and usable on your network!
7.
Press F4 to save your changes and to exit the BIOS setup.
The system automatically shuts down and restarts.
Now you can log on to the IPMI web interface and change the default
password.
8.
To change the default password, open a web browser to http://
<IpAddressOfIPMIport>, and log on with the user name ADMIN in
caps and <password>.
IpAddressOfIPMIport is the station IP address you configured in step
6. The password is located on a sticker that is affixed to the body of the
applicance. The sticker looks very similar to this one.
9.
Choose Configuration > Users, and select the second user account
(ADMIN account).
Advertisement
