Mitsubishi Electric LGF-100GX-E Handbook page 30

Dot display
Intermediate
Major items
items ( Names )
Total opera- Total operation
tion hours hours display
monitor
Total opera-
tion hours of
Lossnay ventila-
tion display
Maintenance Lossnay
address switch
condition
Self diagnosis
( Error history/
Error history
clear )
Memory clear-
ance
*12: Performing the memory clearance operation of the maintenance mode will clear the total operation hours.
*13: Two presses of the remote controller "Clear" button during the self diagnosis display will clear the error history.
Note also that performing the memory clearance operation of the maintenance mode will clear the error history.
*14: The setting content that is stored by the Lossnay unit will not be cleared; therefore, after executing memory
clearance, use the remote controller to perform the function settings again.
Total operation hours, Maintenance items display
MENU (MONITOR/SET) button
Back button
Dot matrix
display
Displays the total Lossnay operation hours.
( The 10,000 and 100,000 hours digits are displayed in
the air supply temperature display area )
Displays the total operation hours when the damper is
on the Lossnay side ( Lossnay ventilation condition ) .
( The 10,000 and 100,000 hours digits are displayed in
the air supply temperature display area )
Displays the address switch condition of the "Main"
Lossnay.
( Example: 001 will be displayed when the address is
number 01 )
Alternately displays at a 0.5 second interval the error
number, generated attribute, and address as the lat-
est error history stored with the remote controller. This
displays the error number and the attribute when the
address has not been set ( i.e., address 00 ) .
"FFFF" will be displayed when the error history is not
available.
Returns all of the remote controller settings and stored
content to the factory setting.
Hold down the "Clear" button of the remote controller.
A change of the display from "rdy" to "End" will indicate
the completion of memory clearance.
Function
─ 30 ─
ON/OFF button
button
CLEAR button
Notes
*12
*13
*14