Pilz PMCtendo SZ Series Operating Manual page 87

List of figures
List of figures
Fig. 1 PMCtendo SZ synchronous servo motors ...................................................................................
Fig. 2 Shielded connection of the power cable (graphic: icotek GmbH) ................................................
Fig. 3 PMCtendo SZ.3x – Turning ranges of the plug connectors.........................................................
Fig. 4 PMCtendo SZ.4x – SZ.8x – Turning ranges of the plug connectors ...........................................
Fig. 5 PMCtendo SZ.3x...K – Turning range of the plug connector .......................................................
Fig. 6 PMCtendo SZ.4x...K – SZ.7x...K – Turning range of the plug connector ....................................
Fig. 7 Forced ventilation unit..................................................................................................................
Fig. 8 Holding brake – Switching behavior ............................................................................................
Fig. 9 PTC thermistor curve (single thermistor) .....................................................................................
Fig. 10 Derating depending on the surrounding temperature ..................................................................
Fig. 11 Derating depending on the installation height..............................................................................
Fig. 12 PMCtendo SZ.3x – Dimensions...................................................................................................
Fig. 13 PMCtendo SZ.3x (HIPERFACE DSL) – Dimensions...................................................................
Fig. 14 PMCtendo SZ.4x – SZ.8x with convection cooling – Dimensions ...............................................
Fig. 15 PMCtendo SZ.4x – SZ.7x with convection cooling (HIPERFACE DSL) – Dimensions ...............
Fig. 16 PMCtendo SZ.4x – SZ.8x with forced ventilation unit – Dimensions...........................................
Fig. 17 PMCtendo SZ output shaft – Dimensions....................................................................................
Fig. 18 SZ.3x – SZ.8x: Fax100 at speeds > 100 rpm ..............................................................................
Fig. 19 SZ.3x – SZ.5x: Frad100 at speeds > 100 rpm.............................................................................
Fig. 20 SZ.7x – SZ.8x: Frad100 at speeds > 100 rpm.............................................................................
Fig. 21 SZ.3x: FMk100 at speeds > 100 rpm ..........................................................................................
Fig. 22 SZ.4x: FMk100 at speeds > 100 rpm ..........................................................................................
Fig. 23 SZ.5x: FMk100 at speeds > 100 rpm ..........................................................................................
Fig. 24 SZ.7x: FMk100 at speeds > 100 rpm ..........................................................................................
Fig. 25 SZ.8x: FMk100 at speeds > 100 rpm ..........................................................................................
Fig. 26 Explanation of a torque/speed curve ...........................................................................................
Operating Manual PMCtendo SZ
1002405-EN-04
9
22
25
26
32
33
36
48
50
51
51
58
59
60
62
64
67
69
69
70
70
71
71
72
72
73
87