Motor Installation; Preparing The Motor For Installation - Pilz PMCtendo SZ Series Operating Manual

Installation
5.2

Motor installation

5.2.1

Preparing the motor for installation

a Check the motor for transport damage. Never install a motor with obvious damage!
a Check the insulation resistance of the motor winding after storage.
a Thoroughly remove any corrosion protection agent and/or dirt from the motor shaft. Use
commercially available solvents to do so. Make sure that solvent does not come in con-
tact with the sealing lips of the shaft seal rings. Otherwise, material damage may occur.
a If possible, warm the drive elements, e.g. belt drive.
a Be aware that damage to the finish on the synchronous servo motor is never permitted.
Operating Manual PMCtendo SZ
1002405-EN-04
CAUTION!
Material damage!
Impacts or other uses of force cause damage to the bearings, feedback sys-
tem and motor shaft.
– Do not hit the motor shaft or motor housing with a hammer or other
tools.
– Do not expose the motor to any compressive stress, impacts or high
acceleration.
– Use backlash-free, frictional collets or couplings.
– For attaching and releasing couplings, gears or belt drives, always
use the intended draw bar thread in the motor shaft. Use a suitable
tool!
CAUTION!
Material damage!
Solvents damage the sealing lips of the shaft seal rings.
– Make sure that no solvent comes in contact with the sealing lips of
the shaft seal rings.
19