L.A. Spas In-Fit 13 SL Manual page 38

ERROR MESSAGES
Message
Hardware error was detected (Ther-
mal fuse)
High Limit circuit has tripped!
No Flow condition; or No Flow
condition for more than 2 hours
Spa temperature is too high
Temp probes or detection circuit are
defective
Elevated internal temperature
Input voltage issue
38
Corrective Action
Reset power to spa. Check for operations of all
pumps and accessories. If error code remains,
call for service.
DO NOT ENTER WATER. Add cold water to spa
and let the heater cool down, reset power to spa.
Reset power to spa. Make sure that the pump
associated to the heater is running. Check and
clean filters and reset the power to see if the error
message goes away. Air locked, prime the pump
(see page 22).
Remove spa cover. Add cold water.
Reset power to spa, if error code remains, call for
service.
Turn off power to the spa to allow the equipment
compartment to cool. If error message occurs
again, call for service.
Call a certified electrician to verify power line
quality.
In-Fit Exercise Pools