Jets And Air Controls; Jets; Cleaning And Replacing Jets - L.A. Spas In-Fit 13 SL Manual

JETS AND AIR CONTROLS

Swim Area Jets
Swim spa jets are designed to produce a
smooth flow of water with high output to
create a consistent swim stream. Whether
you want to swim or walk/jog against the
force of the jets, you will find the flow of
water deep enough and swift enough to
meet your individual needs.
Hydrotherapy Area Jets
All spa jets are individually engineered
to provide a unique hydro-massage.
Depending on the model, your spa will
have a combination of the following jets.
Directional Jets
Positioned to focus on large muscle
groups, these jets deliver a concentrated,
high volume stream of water for a deep
massage. Each jet is fully adjustable,
allowing users to set the water flow to the
most comfortable setting. Nozzle can be
rotated to target sore muscles.
Rotating Jets
Positioned to focus on muscle tension
zones, these jets deliver a spinning
V-shaped water stream for a gentle,
pulsating massage. Each jet is fully
adjustable, allowing for comfortable water
flow settings for everyone to enjoy.
Euro Jets
Positioned in the foot well or shoulder
areas, these jets deliver a penetrating
massage to dissolve tension. This jet may
be the entry point for ozone produced
during automatic filtration and therefore it is
not adjustable.
14
Note: Ozone production is stopped
when functions are activated on control
panel.
Cleaning or Replacing Jets
Hard water can cause calcium/mineral
buildup that can restrict or bind the jets. A
jet consists of a face plate and a nozzle.
Rotate these parts weekly and remove/
clean monthly to ensure free movement.
NOTE: It is not necessary to drain the
spa to clean or remove the jets.
Rotating Jets
• Rotate the jet face left and right
• Return face plate to full open position
• Turn the jets on high speed
• Twist the nozzle left and right
• Rotate the nozzle in the socket
NOTE: If the jet insert disengages from
the spa housing, see steps to reinstall
below.
Cleaning Jets
To REMOVE the jet insert, use the palm
•
of your hand to exert pressure on the face
of the jet. Turn counterclockwise until the
jet 'clicks'. Gently pull the jet assembly
from the housing.
To CLEAN the jet insert and housing,
•
use a pressurized hose and spray the
inside of the jet. Soak the jet in a diluted
spa cleaning solution, rinse. Wipe the
inside of the housing to remove any debris.
To REINSTALL the jet, line up the
•
tab on the backside of the barrel with the
groove in the body. Use the palm of your
hand to gently tap the jet until it snaps into
position.
In-Fit Exercise Pools