Swim Spa System Components - L.A. Spas In-Fit 13 SL Manual

SWIM SPA SYSTEM COMPONENTS

C
A. Filter Skimmer/Weir: Removes
floating debris from the water surface,
provides a water return path to
equipment, and houses water filter
elements.
B. Topside Control Panel: Used to
control temperature setting, jet pumps,
circulation system, underwater lights
and ambient effect lighting.
C. Air Controls: Increases or decreases
air entering the jets. Close during
heating for maximum efficiency. It
is recommended that air controls to the
swim jets remain closed during
swimming to provide a clearer stream of
water which is free from air bubbles.
D. Equipment Pack Service Panel (no
user serviceable parts): Spa support
system consisting of several of the
following devices: electronic control
pack, pumps, heater, UV water sanitizer,
ozone generator, LED lighting interface
and associated electrical controls (not
shown).
12
G
B
E. Drain Access (Adjacent to the
equipment service panel): Drain
faucets are located immediately behind
the front door panel. Remove panel to
access (not shown).
F. Manufacturer's Identification Label:
Contains identification information for
warranty service (serial number, model
number, etc.) and electrical information
(ampere rating and ampere
requirements). Located on the lower
right side of the front door panel (not
shown).
G. Diverter Valve: Used to direct the flow
of water between the massage jets in
the hydrotherapy seats and the swim
jets. By turning the diverter valve
clockwise, the water is directed to the
massage jets in the hydrotherapy seats
and by turning the diverter jet
counterclockwise, the water is directed
to the swim jets.
A
In-Fit Exercise Pools