Assembly - Husqvarna 125C Workshop Manual

3
22
Fuel system
Check that the carburettor is sealed.
No leakage is permitted at 50 kPa.
531 03 06-23
Attach the control diaphragm and
cover.

Assembly

Check that the gasket (A) is
undamaged and that the screws (B) are
in position in the distance piece.
Fit the distance piece on the cylinder.
502 71 27-01
Connect pressure tester 531 03 06-23
to the fuel intake on the carburettor.
Pump up the pressure to 50 kPa.
Lower the carburettor in a vessel with
petrol in order to discover any leaks
more easily.
No leakage is permitted.
Place the gasket on the carburettor
housing and then the control
diaphragm.
Check that the air hole in the cover is
open and screw the cover on.
Assembly
Assemble all parts in the reverse order
as set out for dismantling
Pay attention to the following:
1. Check that the seal (A) in the
groove on the distance piece is
undamaged and seated correctly.
2. Do not forget to position the
carburettor screws (B) in the
distance piece before assembling
the cylinder.
Fit the distance piece on the cylinder
using the two screws (A).
Place the piece of foam (B) in position
and then the insulation above the
distance piece.