Assembly - Husqvarna 325iLK Operator's Manual

• Remove the battery from the product before you
assemble the product.
• Use approved protective gloves.
• A guard that is damaged or does not operate
correctly can cause injury. Do not use a cutting
attachment that does not have an approved guard
attached.
• Make sure that you assemble the cover and shaft
correct before you start the product.
• The drive disc and support flange must engage
correctly in the centre hole of the cutting attachment.
A cutting attachment that is attached incorrectly can
cause injury or death.
• If a harness is supplied with the attachment, the
harness must be correctly attached to the product.
The harness makes operation safe and prevents
injury to the operator or other persons.
Safety instructions for maintenance
WARNING:
instructions that follow before you do
maintenance on the product.
To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows. Do not place loop handle or suspension ring
on label. (Fig. 26)
2. Move the spacer into the slot of the loop handle.
3. Attach the nut, the knob and the screw, do not make
it to tight.
4. Adjust the product to a comfortable position.
5. Tighten the bolt.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling. (Fig. 27)
2. Align the tab (A) with the arrow (B) on the coupling.
(Fig. 28)
3. Push the shaft into the coupling until it clicks into
position. (Fig. 29)
4. Tighten the knob fully. (Fig. 30)
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling. (Fig. 31)
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the motor is
attached to.
4. Pull the attachment out of the coupling. (Fig. 32)
785 - 007 - 10.10.2023
Read the warning

Assembly

• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
• Always use heavy duty gloves when you repair the
cutting attachment. The blades are very sharp and
can easily cause injuries.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING:
WARNING:
attachment guard that is recommended for
the cutting attachment. See
on page 17 .
WARNING:
cutting attachment can result in injury or
death.
To install the suspension ring if applicable
1. Install the suspension ring between the arrows on
the rear handle and the loop handle. (Fig. 33)
Note:
Do not put the loop handle on the decal.
2. Adjust the ring to make the product balanced, and
easy to use.
Use protective gloves.
Always use the cutting
Technical data
An incorrectly attached
13