Table of Contents
Advertisement
Operation manual
Important Safety warnings
WARNING!
Whether a specific machine application and G9SR system installation complies with
applicable directives and standards depends on the proper application, installation,
maintenance and operation of the G9SR system. These items are the responsibility of the
purchaser, installer and employer. The employer is responsible for the selection and
training of personnel to properly install, operate and maintain the machine and its
safeguarding systems. A G9SR system should only be installed verified and maintained
by a qualified person. A qualified person is defined as "an individual who understands, is
trained on, and demonstrates competence with the construction, operation or
maintenance of the machinery and the hazards involved."
To use the G9SR system the following requirements must be met:
•
Observe the instructions in this manual regarding test regulations (e.g. on use,
mounting, installation or integration into the existing machine control system)
carefully.
•
Periodic tests must be carried out by specialist personnel or specially qualified
and authorized personnel and must be recorded and documented to ensure that
the tests can be reconstructed and retraced at any time.
•
The operating instructions must be made available to the operator of the
machine where the G9SR system is installed.
•
The machine operator is to be instructed in the use of the device by specialist
personnel and must be instructed to read the operating instructions.
•
The guarded machine must have a consistent stopping time and adequate
control mechanisms.
This manual refers to FW release 1.0.0 and HW release 1.0 and 2.0.
Read and understand this section prior to installing a G9SR
system.
G9SR
XIII
Advertisement
Table of Contents
