Advertisement
SoftStop
® Tangent End Terminal
3.0 Recommended Tools
Documentation
• Assembly Manual (Most Current Version)
• System Drawing (Most Current Version)
Personal protective equipment (PPE)
• Safety Glasses
• Work Gloves
• Safety-Toe Shoes
• Back Protection
• Hard Hat
• Reflective Vest
• Hearing Protection
Note: The above list of tools is a general recommendation only and should not be considered an exhaustive list.
Depending on speci c site conditions and the complexity of the assembly (or repair) speci ed by the appropriate
highway authority, additional or fewer tools may be required. Decisions as to what tools are needed to perform the job
are entirely within the discretion of the specifying highway authority and the authority's selected contractor performing
the assembly of the system at the authority's speci ed site.
4.0 SoftStop® System Site Preparation
The SoftStop® System is a tangent, single-sided, energy-absorbing, redirective and gating end terminal system that
state/specifying agency specify for use as speci ed by the appropriate state/specifying authority in conjunction with
W-beam guardrail on the shoulder or median of a roadway. The decision to specify the SoftStop® System for a particular
project is the responsibility of the state/specifying agency design engineer who must ensure that the most appropriate
end terminal has been selected for the speci c site conditions.
Important: Do not attach the SoftStop® System directly to a rigid barrier (i.e. concrete barrier, wall or
bridge pier) without the use of a state/specifying agency approved transition.
Important: Ensure that the SoftStop® System assembly conforms to the local road design standards.
Important: Ingal Civil Products does not direct grading. Proper site grading must be accomplished
before assembly of the SoftStop® System in accordance with road controlling guidelines and
requirements. Failure to follow this warning could result in serious injury or death in the event of a
vehicle impact or collision.
Release 06/19
Miscellaneous
• Traffic Control Equipment
• SAE Combination Wrench Set
• Socket Set & Socket Wrench
• Hammer
• Chalk Line
• Tape Measure
• Marking Paint and Pen
• Straight Edge
• Level
• Plumb Line
• Post Pounder (commonly used for driving posts)
• Auger
• Soil Tamper
• 5/8"AlignmentTool(DriftPin)
• Locking Pliers
• C-Clamps
9
Advertisement
