Advertisement
SoftStop
STEP 10
Angle Strut Assembly (Posts 0-1)
Note: Items below grade
shown for clarity.
PARTS
BB
10001299
2 EA
X
10007095
4 EA
R
10007551
1 EA
M
10007544
2 EA
N
10007547
1 EA
S
10007092
1 EA
Use only Trinity Highway parts
that are speci ed herein for the
SoftStop® System for assembling,
maintaining, or repairing the
SoftStop® System. Do not utilise
or otherwise comingle parts from
other systems even if those systems
are Trinity Highway systems.
Release 06/19
® Tangent End Terminal
1. Assemble all parts in the con guration & orientation shown above.
2. It will be necessary to make a shallow valley/trough between Post 0 & 1 for the
SoftStop® Angle Strut (Part N) and SoftStop® Anchor Angles (Part M), since a
portion will be below the nished grade.
3. Position the SoftStop® Anchor Angles (Part M) onto Post 0 and place SoftStop®
Angle Strut on the non-tra c side with short leg down and fasten to Post 0 & 1
using shown hardware (Part R, S, X, BB).
4. Tighten all threaded hardware to a snug position with an appropriately sized
wrench or socket.
Ensure fully assembled SoftStop® Anchor Post height (with
SoftStop® Anchor Angles) does not exceed 102mm above
nished grade line.
INSTRUCTIONS
WARNINGS
26
Advertisement
