Advertisement
SoftStop
® Tangent End Terminal
STEP 7
Impact Head Assembly
PARTS
A
10007538
1 EA
P
10007553
1 EA
Y
10007554
2 EA
CC
10007555
1EA
Use only Trinity Highway parts
that are speci ed herein for the
SoftStop® System for assembling,
maintaining, or repairing the
SoftStop® System. Do not utilise
or otherwise comingle parts from
other systems even if those systems
are Trinity Highway systems.
Release 06/19
1. Assemble all parts in the con guration & orientation shown above.
2. Mechanically push the SoftStop® Impact Head (Part A) until its Connection
Bracket rests against Post 1 and a minimum 457 mm of the SoftStop® Anchor
Rail is protruding out the Chute.
3. Fasten Post 1 and the Connection Bracket together with shown hardware (Parts
P, Y, & CC) and tighten. See Connection Bracket detail.
4. Mechanically lift the exposed Anchor Rail until it aligns with the slot in the
Anchor Post (Post 0) when at rest.
The SoftStop® Impact Head Connection Bracket must rest
against the front side of Post#1 (between Posts 0-1) as
shown in the Connection Bracket Detail above.
INSTRUCTIONS
WARNINGS
23
Advertisement
