Advertisement
SoftStop
STEP 2
Post Assembly (Posts 0-2)
PARTS
F
10001402
1 EA
E
10007539
1 EA
D
10007543
1EA
Use only Trinity Highway parts
that are speci ed herein for the
SoftStop® System for assembling,
maintaining, or repairing the
SoftStop® System. Do not utilise
or otherwise comingle parts from
other systems even if those systems
are Trinity Highway systems.
Release 06/19
® Tangent End Terminal
1. Assemble all parts in the con guration & orientation shown above.
2. Ensure proper o set for Post 0 (Part D) and Post 1 (Part E) is as shown on
dimension above and on the Post Displacement Diagram (page 30).
3. Ensure center of yielding holes for Post 1 & 2 are approximately at nished
grade, as shown.
4. Ensure Post 0 stub height does not exceed 89 mm above nished grade.
5. Ensure proper post spacing and post height is achieved per shown dimensions
above.
Proper site grading must be accomplished in accordance
with local road authority guidelines. Failure to follow this
warning could result in serious injury or death in the event
of a vehicle impact or collision with the system.
INSTRUCTIONS
WARNINGS
18
Advertisement
