Advertisement
SoftStop
6.2
SoftStop® System Anchor Post (Post 0) Placement
The SoftStop® System Anchor Post (10007543) is the rst post of the SoftStop® System and is designated as Post 0. The
SoftStop®System Anchor Post is to be assembled plumb and oriented with the front side of post facing towards the
upstream end.
A. When assembled to the correct depth, the SoftStop® System Anchor Post stub will protrude 89 mm above the nished
grade line (see Step 2 of this Assembly Manual).
B. When fully assembled, the SoftStop® System Anchor Post (with Anchor Angles) will protrude 102 mm above the
nished grade line (see Step 12 of this Assembly Manual).
Caution: Ensure the SoftStop® System Anchor Post is assembled in the orientation shown above.
Caution: Ensure the SoftStop® System Anchor Post is assembled in the orientation shown above.
Failure to follow this warning could result in serious injury or death in the event of a vehicle impact or
Failure to follow this warning could result in serious injury or death in the event of a vehicle impact or
collision with the system.
collision with the system.
Upstream
B. Anchor Post (Fully Assembled) at Correct Height
Upstream
Figure 10: Anchor Post (Post 0) placement
Release 06/19
® Tangent End Terminal
A. Anchor Post Stub at Correct Height
Finished Grade Line
Anchor Angle (2EA)
Finished Grade Line
14
Advertisement
