Advertisement
SoftStop
STEP 8
Anchor Paddle Assembly
PARTS
I
10007542
1 EA
W
10001284
4 EA
AA
10001285
2 EA
Q
10001286
2 EA
Use only Trinity Highway parts
that are speci ed herein for the
SoftStop® System for assembling,
maintaining, or repairing the
SoftStop® System. Do not utilise
or otherwise comingle parts from
other systems even if those systems
are Trinity Highway systems.
Release 06/19
® Tangent End Terminal
1. Assemble all parts in the con guration & orientation shown above.
2. Flatten the exposed Anchor Rail, line up holes using an alignment tool onto the
rail and insert the hex bolts and bottom washers as shown above. The Anchor
Paddle (Part I) is assembled on the top side of the four (4) plies of the protruding
Anchor Rail. Place the top washers and nuts onto the hex bolt as shown above.
The use of locking pliers or c-clamps will aid the assembly process.
3. Tighten all threaded hardware to a snug position with an appropriately sized
wrench or socket.
The SoftStop® Anchor Paddle (Part I) must be placed on the
topside of the SoftStop® Anchor Rail. Failure to follow this
warning could result in serious injury or death in the event
of a collision.
INSTRUCTIONS
WARNINGS
24
Advertisement
