Supermicro X12SAE User Manual page 90

Super X12SAE/X12SCA-F User's Manual
Network Stack
Select Enabled to enable UEFI (Unified Extensible Firmware Interface) for network stack
support. The options are Disabled and Enabled.
*If this feature is set to enabled, the following features will become available for
configuration:
Ipv4 PXE Support
Select Enabled to enable IPv4 PXE (Preboot Execution Environment) for boot support. If
this feature is set to Disabled, IPv4 PXE boot option will not be supported. The options are
Disabled and Enabled.
Ipv4 HTTP Support
Use this feature to enable IPv4 HTTP boot support. The options are Disabled and Enabled.
Ipv6 PXE Support
Select Enabled to enable IPv6 PXE (Preboot Execution Environment) for boot support. If
this feature is set to Disabled, IPv6 PXE boot option will not be supported. The options are
Disabled and Enabled.
Ipv6 HTTP Support
Use this feature to enable IPv6 HTTP boot support. The options are Disabled and Enabled.
PXE boot wait time
Enter a value for the wait time (in seconds) to press the <ESC> key to abort the PXE
boot. The default is 0.
Media detect count
Enter a value for the number of times the presence of media will be checked. The
default is 1.
SATA And RST Configuration
SATA And RST Configuration
SATA Controller(s)
This feature enables SATA device(s). The options are Disabled and Enabled.
*If this feature is set to Enabled, the following features will become available for
configuration:
SATA Mode Selection
This feature controls SATA mode(s). The options are AHCI and Intel RST Premium With
Intel Optane System Acceleration.
90