Front Control Panel - Supermicro C9Z490-PG User Manual

Super C9Z490-PG/-PGW User's Manual

2.7 Front Control Panel

JF1 contains header pins for various buttons and indicators that are normally located on a
control panel at the front of the chassis. These connectors are designed specifically for use
with Supermicro chassis. Refer to the figure below for the descriptions of the front control
panel buttons and LED indicators.
Note: You may connect the JF1 using the bundled S-Connector. The S-Connector is a
plug designed to connect the front control panel header on the motherboard and front
control panel cables of chassis. Please align the printed indications on the S-Connector
with the corresponding pins on JF1 when plugging in. Refer to the checklist table in
Section 1.1 and contact Supermicro for more detailed connector information.
MAC CODE
MAC CODE
JI2C2
JI2C1
JSTBY1
JL1
CPU LED
DIMM LED
VGA LED
BOOT LED
10G LAN
Controller
BAR CODE
MH10
MH15
1
MH11
3
MH13
MH12
B1
BIOS
PCIE M.2-M2
LICENSE
PCIE M.2-M1
LED3
MH14
PCH
Super I/O
JLED1
JWD1
USB12 (3.2(10Gb))
I-SATA2 I-SATA0
I-SATA3 I-SATA1
SYS_FAN2
15
POWER LED (-)
HDD LED (-)
NIC1 LED (-)
NIC2 LED (-)
Overheat/
Fan Fail LED (-)
X
Ground
Ground
1
Figure 2-2. JF1 Header Pins
USB8 (3.2(10Gb))
USB9 (3.2(20Gb))
HD AUDIO
LAN2
USB6/7 (3.2(10Gb))
JRLED1
WiFi+BT
LAN Controller
SYS_FAN3 LED18
LED17
PLX
C9Z490-PGW DIMMA1
DIMMA2
REV:1.01 DIMMB1
DESIGNED IN USA DIMMB2
JPW1
16
POWER LED (+)
HDD LED (+)
NIC1 LED (+)
NIC2 LED (+)
Overheat/
Fan Fail LED (+)
X
Reset Reset Button
PWR Power Button
2
38
DP/HDMI
LAN1
USB4/5 (3.2(5Gb))
12V_PUMP_PWR1
CPU_FAN1
POWER RESET
BUTTON BUTTON
CLEAR CMOS
SYS_FAN1