PIT si1.1
Wiring
Perforate the stuffing box using a screwdriver.
}
The power supply is fastened underneath the bulb holder with the aid of the two screw
}
terminals. Press the terminals beside lamp holder to the side and push the wire into the
cutouts above the holder.
Fig.: Wiring
Installation
Install the base directly on a horizontal surface or on the fastening bracket using the
}
two screws supplied.
Install the fastening bracket with the base on a vertical surface.
}
Fig.: Installation
Operating Manual PIT si1.1
21040EN03
CAUTION!
Wire the lamp when it is isolated from the power supply.
2 cores
7