Xinje ZG3 Series User Manual page 80

High 16 bits of Electrical origin
SFD1691
position
Mechanical
SFD1692
parameter setting
Terminal setting of near point
SFD1693
signal
SFD1694 Z phase terminal setting
SFD1695 Limit terminal setting
Terminal
SFD1696
auxiliary signal
Terminal setting of zero clear
SFD1697
CLR signal output terminal
SFD1698 Low 16 bits of return speed VH
SFD1699 High 16 bits of return speed VH
SFD1700 Low 16 bits of return speed VL
SFD1701 High 16 bits of return speed VL
SFD1702 Low 16 bits of crawling speed
SFD1703 High 16 bits of crawling speed
SFD1704 Low 16 bits of mechanical origin
High 16 bits of mechanical
SFD1705
origin
SFD1706 Z phase number
SFD1707 CLR signal delay time
G instruction parameter group
SFD936
using choice
...
Low 16 bits of pulse default
SFD1730
speed
High 16 bits of pulse default
SFD1731
speed
Accelerating
SFD1732
default speed
Decelerating
SFD1733
default speed
SFD1734 Acc and Dec time of tween
SFD1735 Reserved
back to origin
setting of origin
time of pulse
time of pulse
Bit0：Switch state setting of near
point, 0 ： Normally ON ；
1Normally OFF
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
Bit7~bit0： Assign limit 1 number
of terminal X, 0Xff for not
terminal
Bit15~bit8 ： Assign limit 2
number of terminal X, 0Xff for
not terminal
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
Bit0~bit7：Assign the number of
terminal Y, 0Xff for not terminal
Default 20, unit：ms
Choose the G
parameter group
Only when speed is 0, default
speed is used to transmit pulse.
instruction
First set of
parameters