Table of Contents
Advertisement
W i n d o w s
P C
S o f t w a r e
P A GE 4 8
4.9.2.6.1
Hold Signal Recording/Source
The Hold-signal can be configured via this dialog. Apart from the normal in-
terface selection the possibility exists to store an individual signal of 8 seconds
duration in the system. This signal is given in cycles.
FIG. 23
General Settings
Hold Signal Source
Specify here the source from which the Hold signal should be generated. Se-
lection can be from the audio interfaces, which are configured as On Air or
Hold (see 4.9.1.5, page 38).
However there is also the possibility of storing a particular Hold signal in the
system and to output this signal. Choose Recorded Hold Signal for this.
Pause between Repetition
When using a generated Hold signal, the pause in seconds between the repe-
titions can be defined.
Hold Signal Length
The length of the recorded Hold signal is displayed here.
Record Signal
Record Source
Select here the source for the recording of the Hold signal.
CONFIGURATION OF THE HOLD-SIGNAL
Advertisement
Table of Contents
