AVT MAGIC Hardware & Software Manual page 38

W i n d o w s P C S o f t w a r e
P A GE 3 8
4.9.1.5 Audio Line Settings
Under Audio Line Settings, the audio interfaces of the system can be config-
ured.
NOTE See CHAPTER A1, page 57 for the table of the audio interface assignment for
different modes.
FIG. 18
If the AES/EBU/Analogue Module is not fitted, the system has only one ana-
logue audio interface. The caller's On Air signal is stored under Assignment 1.
In addition when it is desired to use the optional handset on the same inter-
face, the Pre Talk function can be selected under Assignment 2.
The system has three relays. One of these relays is used for signalling the Pre
Talk mode (see CHAPTER A2.5, table 13). The mixer can be connected via this
relay.
NOTE If the AES/EBU/Analogue Module is not fitted in the system, no further set-
tings can be made.
When the optional AES/EBU/Analogue Module (CHAPTER A2.7.1, page 65)
is fitted, the system is expanded to two analogue or two digital AES/EBU au-
dio inputs/outputs. In general these inputs and outputs can be configured as
desired.
CONFIGURATION OF THE AUDIO INTERFACES WITHOUT MODULE