Table of Contents
Advertisement
W i n d o w s
P C
S o f t w a r e
Auto Answer Call
Incoming calls can be accepted by the system automatically. Set the relevant
check mark.
To prevent auto calls being answered automatically, leave the box unchecked.
If there is an incoming call the relevant message is displayed on the PC.
If the individual mode is not configured another combination field appears.
In this field it can be defined to which line the caller should be routed. The se-
lection depends on the audio interfaces available.
Incoming Call Signalling (Relay 1 Behaviour)
The system has three relays. One relay is used for external call signalling (see
A2.5, page 64).
The combination field allows the following settings:
– always open: the relay is always open
– always closed: the relay is always closed
– System controlled: if there is an incoming call on any channel the relay is
closed
Enable System Buzzer
Faulty operations or warning signals can be signalled in the system by a
buzzer. To enable this system buzzer set the relevant check mark.
Mix caller in HOLD to PRE TALK output
NOTE
This function is only available for systems equipped with AES/EBU/Ana-
logue Modules. Additionally, a Hold Line must be configured.
If this function is activated the signal of callers in the Hold mode of the
MAGIC Hybrid Keypad are mixed with the signal of the caller in Pre Talk.
These callers do not hear the outgoing Pre Talk signal. The purpose of this
function is so that callers in Hold can immediately attract attention.
Call Forwarding
The system supports call forwarding. The Program Presenter only has to
press one button on the MAGIC Hybrid Keypad to forward the call to the ed-
itorial department. This is quite useful for example, after a game show when
the address of the caller is to be written down. To be independent from ISDN
installations, the call forwarding is made to a B-channel on the system. The
caller is still kept in the system. Thus the Program Presenter has the possibility
get the caller back.
Number of line used for Call Forwarding
The last B channel of the last S
line should always be entered here. For one S
0
0
line, enter B channel 2, for two S
lines, enter B channel 4.
0
P A GE 4 5
Advertisement
Table of Contents
