AVT MAGIC Hardware & Software Manual page 44

W i n d o w s P C S o f t w a r e
P A GE 4 4
Additionally, when the keypad is active, the choice of using the standard op-
erating mode is also available. The standard mode is automatically set up af-
ter turning on the system. The following modes can be chosen:
– Standard Mode: if this setting is selected, only one of the caller is On Air.
All other callers hear the Hold Signal. On the display of the MAGIC Hybrid
Keypad the message Standard is shown.
– Conference Mode: all callers are automatically mixed in a conference and
are On Air simultaneously. On the display of the MAGIC Hybrid Keypad
the message Conference is displayed.
– Next Mode: the callers are automatically put on Hold. By pressing the Next
key on the MAGIC Hybrid Keypad, the first caller is put On Air. Pressing
this key once again drops this connection and the next caller is put On Air,
and so on. The MAGIC Hybrid Keypad shows Next on the display.
NOTE The table of audio interface assignments with the keypad can be found in
CHAPTER A1, page 57.
Use Individual On Air Lines Mode
NOTE This function is only relevant for systems equipped with AES/EBU/Analogue
Modules.
This option activates the Individual Mode of the Hybrid. All callers are routed
to their individual audio interfaces. With this function, the Hybrid can be
used as a triple ISDN Telephone Hybrid.
Enable Pre Talk
When the Individual Mode is turned on, there is additionally the possibility
to activate the Pre Talk operating mode. Please note that the Pre Talk mode
also needs an audio interface.
NOTE The table of audio interface assignments with this configuration can be found
in CHAPTER A1, page 57.
S Protocol
0
Select here the desired S
Sometimes the old German national 1TR6 protocol can be found in PABXs.
Number of max. Incoming Calls
The MAGIC ISDN Telephone Hybrid has a maximum of four B channels into
which callers can dial in simultaneously. Therefore a telephone conference
with up to four participants can be accomplished very easily.
Enter 2 when only one S
connected. To prevent several callers calling in simultaneously, the value
must be set to 1.
NOTE If the individual mode is activated, a maximum of 3 callers can dial into the
system simultaneously.
Protocol. In most cases it is EDSS1 (Euro ISDN).
0
line is connected. Enter 4 when a second S
0
Line is
0