Table of Contents
Advertisement
FIG. 19
When using the digital AES/EBU outputs the clock which drives these inter-
faces should be set under Clock Source of Digital Output. The following set-
tings are possible:
– Recovered Clock (from digital audio input)
This setting can only be used when the digital input is connected to a dig-
ital source. The digital output signal is then synchronised to the digital in-
put signal.
– Internal Clock
The clock for the release of the digital output signal is generated internally.
In this case the sampling rate is always 48-kHz.
– External Clock
With this setting the clock, which the digital output signa is fed, must be
fed in via the BNC-socket. The sampling rate must be 48-kHz. The relevant
„word" clock is available by the BNC-socket as an output.
Select the system Master and press the Edit key to choose the analogue input
audio-interfaces. Set analogue in the displayed panel.
Thus three analogue inputs ( the already existing audio interface of the system
+ two other interfaces on the module) and three analogue audio outputs are
available. The two analogue outputs on the module are additionally imple-
mented in parallel on the digital output interfaces of the module. Set the clock
source in Clock Source of Digital Output to Internal Clock.
The digital
pressing the Edit key and then setting digital, there are one analogue and two
digital audio inputs available. Additionally the system has two digital and
one analogue output. The digital outputs of the module are also implemented
in parallel on the analogue audio interfaces of the modules. The digital in- as
1 Please note that physically this is only one AES/EBU interface.
CONFIGURATION OF THE AUDIO INTERFACES WITH MODULE
1
inputs of the module are chosen by selecting the system Master,
W i n d o w s
P C
S o f t w a r e
P A GE 3 9
Advertisement
Table of Contents
