System Configuration Without Keypad - AVT MAGIC Hardware & Software Manual

W i n d o w s P C S o f t w a r e
P A GE 3 2
4.9.1

System configuration without keypad

Clicking Configuration -> System opnes system configuration window.
The configurations are summarized under different tabs. They are described
in detail for use without the keypad.
4.9.1.1 General Settings
FIG. 13
Keypad available
When using the MAGIC without the Hybrid Keypad this option must not be
set. This setting provides further functionalities as well as assignment of au-
dio interfaces.
NOTE The audio interface assignment table without keypad can be found in
CHAPTER A1, page 57.
Use Individual ON AIR Lines Mode
NOTE This function is only relevant for systems equipped with AES/EBU Analogue
Modules (see Fig. 5, page 22)
With this option the hybrid can be switched to individual mode. All callers
are then routed to their own audio interface. Now the hybrid can be used as
triple ISDN Telephone Hybrid.
NOTE The audio interface assignment table for this configuration can be found in
CHAPTER A1, page 57.
S Protocol
0
Choose the correct S
GENERAL SETTINGS
protocol. In most cases it is the EDSS1 (Euro ISDN).
0