i-SENS CareSens N Owner's Booklet page 17

Step 9
After the symbol appears on the screen, apply the
blood sample to the narrow end of the test strip till the meter
beeps.
If the confirmation window is not filled in time due to abnormal
viscosity (thickness and stickiness) or insufficient volume, the
Er4 message may appear.
It is recommended to place the test strip vertically into the
blood sample site as shown below.
Caution:
Do not allow any foreign substances, such as dirt, blood, or
water, enter into the meter. The meter may be damaged or
may malfunction. Follow the warning information provided
below to prevent possible damage to the meter.
• Do not apply the blood sample directly to the test strip port.
• Do not apply the blood sample to the test strip while
holding the meter in a way that the tip of the test strip faces
upwards. The blood sample may run down the surface of
the test strip and flow into the test strip port.
• Do not store your meter in unsanitary or contaminated sites.
30 www.i-sens.com
Good Sample Insufficient
Sample
Note: The meter may switch off if the blood sample is not
applied within 2 minutes of the
on the screen. If the meter turns off, remove the strip and
reinsert it and apply blood sample after the
appears on the screen.
Step 10
Apply the blood sample to the narrow end of the test strip until
you hear a beep. At this time, the display segments will rotate
clockwise while the blood is going in.
Test result will appear after the meter counts down from 5 to 1.
The result will be automatically stored in the meter's memory.
If the test strip is removed after the test result is displayed, the
meter will automatically switch off after 3 seconds. Discard
used test strips safely in disposable containers.
symbol appearing
symbol
Test result
www.i-sens.com 31