Configuring The Tlp 700Mv (Initial Setup); Setup Menu; Calibration Menu; Reset Modes - Extron electronics TouchLink TLP 700MV Setup Manual

Configuring the TLP 700MV (Initial Setup)

Before using the TLP 700MV, it is essential to configure it using the on-screen menus. There are five different screens (Main, Volume,
Time, Network, and Video) that can be selected by pressing the appropriate button at the left side of the screen. There is also an Exit
button at the bottom left corner of the screen for leaving the menus.

Setup Menu

Menu
Press the recessed
Main
menu opens at the
Touch an area of the screen to bring it into focus and use the
buttons or the volume control knob to adjust the value. Some options
have a single button and toggle between
pressed.
Use the different menu pages to adjust the following options. For
more details, see the TLP 700MV and TLP 700TV User Guide at
www.extron.com.
Main (see figure 3) — Adjusts the
Backlight LED Backlight
,
Master
Volume — Adjusts the
settings.
Time — Sets the correct time and date.
Network — Sets the IP address and the subnet mask, and enables or
disables Dynamic Host Configuration Protocol.
Video — Provides a small video preview window and the controls to set up
the video contrast, color, brightness, and tint.

Calibration Menu

Setup
While in the menu, press the
the calibration-screen. When all four points have been calibrated, the
Setup
screen reopens to the
Exit
Press to close the on-screen menus.
Reattach the faceplate (see

Reset Modes

The TLP 700 MV has four reset modes that can be initiated by pressing the
NOTE: See the TLP 700MV and TLP 700TV User Guide at
Factory Firmware Mode — Hold the
•
with the unit.
Run/Stop Events Mode — Hold the
•
momentarily (less than 1 second) within 1 second.
This mode turns events on or off.
Reset All IP Settings Mode — Hold the
•
Reset
momentarily (less than 1 second) within 1 second.
This mode resets the IP address, subnet, gateway, port mapping, and DHCP settings back to factory defaults. The reset LED
blinks 4 times in quick succession, confirming the reset and turning events off. If necessary, reset the IP address, using ARP and
the MAC address.
Reset Factory Defaults Mode — Hold the
•
Reset momentarily (less than 1 second) within 1 second.
This mode causes a reset to factory defaults for everything except firmware.
NOTES:
The factory configured passwords for all accounts on this device have been set to the device serial number. Passwords
•
are case sensitive.
If the device is reset to default settings, the password will be the default password configuration. The default password
•
is extron.
button to activate the top-level menu screen. The
Setup Page.
Off On
and when the button is
Sleep timer Backlight
,
Wake on Motion
, and
Click Sounds
, , , and
Menu
button a second time to open
screen.
Figure 2
on page 2).
Reset
button while applying power to reset the unit back to the base firmware shipped
Reset
button until the reset LED blinks once (3 seconds), then release and press
Reset
button until the reset LED blinks twice (6 seconds), then release and press
Reset
Up Down
and
Auto
,
functions.
Line In
volume
Figure 3.
Figure 4.
Reset
button.
www.extron.com for additional details.
button until the reset LED blinks 3 times (9 seconds), then release and press
Product Category
Setup Menu
Calibration Screen
Reset
3