Tutorial - Elcometer 355 Operating Instructions Manual

R

17 TUTORIAL

This tutorial is intended to demonstrate the features of the Elcometer 355 Standard instrument and is
designed to work with an F1 module fitted to an unused Elcometer 355. If other modules are used, or if
information is stored from previous operations, the response of the instrument to the commands below may
be different. It is also intended to familiarise the User with of the functions of the Elcometer 355, but actual
use of the instrument depends on application and requirements of the process.
17.1 Switch ON
To switch on press and hold [ ]. Note display of all segments and software
identification.
The instrument 'wakes up' in the mode last used. To switch off, press and hold
[ENTER] for approximately 3 seconds).
Note: The instrument will normally switch off automatically after 1 minute if no operation is carried out - see
"Date and time" on page 18 to adjust.
17.2 Select Immediate Mode (Batch 0)
Press [BATCH] and the display will flash:
42