Table of Contents
Advertisement
R
Code
Explanation
E11
No readings were taken before trying to enter a base or cal factor.
E12
Limits cannot be changed in a batch with readings.
E13
Batch number entered cannot be found or Selected batch type not available.
E14
The probe module currently used is different to when this batch was created.
E15
The probe module is not responding or is not plugged in.
E16
Maximum number of batches exceeded.
E17
The limit set exceeds the range of the probe module in use.
E18
Calibration Factor error. Too large a value has been entered for a Cal Factor.
E99
Cannot complete standard deviation calculation
34
Hide quick links:
Advertisement
Table of Contents
