Elcometer 355 Operating Instructions Manual page 13

Immediate mode is designated as 'BATCH 0'. Returning to immediate mode from batch mode clears all
previous immediate mode data and starts at reading '0'.
The time and day/month will always be stored at the time when the first reading is taken.
In addition, if the time stamp mode is enabled (see "Date and time" on page 18) it will also be stored within
the batch data whenever the instrument is:
• switched off automatically
• switched on again
• instructed that the batch is closed, normally by opening another batch.
5.2 VIEWING BATCH DATA
Data within the current batch may be viewed by pressing [BATCH] and [.]. Other batches may only be
viewed by first selecting them. Viewing always starts at the beginning of the batch.
Use [<] and [>] to scroll through the data.
Embedded within data, and shown in the reading number display, are 'OP' which indicates when the batch
was opened, 'On' to indicate when the instrument was switched on and 'CL' to indicate when the batch was
closed, along with the time and date (month and day only) alternately flashing. (The date format may be
either mm:dd or dd:mm - see "Date and time" on page 18).
Also embedded are any base or cal functions which are completed within the batch. The beginning of the
viewed data may be selected by pressing [BASE], the middle by pressing [CAL] and the end by pressing
[LIMIT].
Note: The beeper is switched off automatically so that only a click sounds when scrolling through the data.
R
11