Troubleshooting; Specifications - Panasonic MX-EX1081 Operating Instructions Manual

Before calling for service, please check through this section.
Problem
Even turn to "1"
position, the
appliance
does not start
blending.
Rotation stops
abruptly.
There is abnormal
noise or vibration
increases.
The ingredient is
leaking.
The blade is idling.
Power supply
Power consumption
Rated time
Working capacity
(approximately)
Dimensions
(approximately)
Mass. (approximately)
EN8

Troubleshooting

■ ● The blender jug / mill container is not set properly.
➝ Make sure to align the marks on blender jug base / mill container base and motor housing,
then twist it firmly until you hear a "click" sound.
■ ● The blender jug base / mill container base is not assembled tightly.
➝ Assemble it tightly. (P. EN6)
■ ● The protection device of overload or overheating is activated.
➝ Refer to "Overload and Overheating Protection" for inspection. )P. EN7(
■ ● The power plug is disconnected.
➝ Insert the power plug into outlet firmly.
■ ● The protection device of overload or overheating is activated.
➝ Refer to "Overload and Overheating Protection" for inspection. )P. EN7(
■ ● Too much ingredients.
➝ Reduce ingredient amount.
■ ● The blender jug base / mill container base is not assembled tightly.
➝ Assemble it tightly. (P. EN6)
■ ● The blender jug base / mill container base is not assembled tightly.
➝ Assemble it tightly. (P. EN6)
■ ● The blender gasket / mill gasket is not attached or attached loosely.
➝ Attach it properly.
■ ● Foreign matters are stucked around blender gasket / mill gasket.
➝ Remove them.
■ ● The blender gasket / mill gasket is damaged.
➝ Contact Panasonic Service Center to replace it.
■ ● The liquid amount is not enough.
➝ Add more liquid.
■ ● Too much ice cubes. (e.g. juice with a lot of ice)
➝ ① Remove blender jug after rotation stop completely.
② Shake the blender jug gently.

Specifications

When the blender is used
Continuous operation (Repeat the cycle
of 3 minutes ON and then 1 minute OFF)
W
D
H
Cause and Action
220 - 240 V
250 - 275 W
1 000 mL
172 mm
161 mm
362 mm
2.4 kg
When the wet & dry mill is used
50 - 60 Hz
Continuous operation (Repeat the cycle
of 1 minute ON and then 2 minutes OFF)
Dry: 50 g / Wet: 200 mL
148 mm
161 mm
260 mm
1.6 kg