Eaton Cutler-Hammer D64RP14 Series Instruction Manual page 13

D64RP14 SERIES A2 DIGITAL GROUND FAULT RELAY
EN 61000-6-2
EN 61000-4-2
EN 61000-4-3
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
EN 61000-4-11
EN 60947-5-1
IEC 60755
UL
CSA
CE
External Current Transformer (when required)
Use Eaton's Cutler-Hammer C311CT series with 500:1 ratio, listed in section 4 – Catalog
Numbers.
Revision 1
May, 2005
Electromagnetic compatibility (EMC) - Part 6-2 Generic standards–
Immunity standard for industrial environments (note: = highest levels):
80-1000 MHz with 80% AM modulation up to 10 V/m at 3m distance from
source
Electromagnetic compatibility (EMC) for industrial-process measurement
and control equipment – Part 4-2: Electrostatic discharge (ESD) immunity
Electromagnetic compatibility (EMC) for industrial-process measurement
and control equipment – Part 4-3: Radiated electromagnetic field immunity
Electromagnetic compatibility (EMC) for industrial-process measurement
and control equipment – Part 4-4: Electrical fast transient/burst immunity
Electromagnetic compatibility (EMC) for industrial-process measurement
and control equipment – Part 4-5: Surge immunity
Electromagnetic compatibility (EMC) for industrial-process measurement
and control equipment – Part 4-6: Conducted radio frequency field
immunity
Electromagnetic compatibility (EMC) for industrial-process measurement
and control equipment – Part 4-11: Voltage dips/drops/variations immunity
Low-voltage switchgear and controlgear – Part 5-1: Control circuit devices
and switching elements – Electromechanical control circuit devices
General requirements for residual current operated protective devices
UL 1053 Ground-Fault Sensing and Relaying Equipment, Class 1
UL File E195341
C22.2 No. 144-M91 Ground Fault Circuit Interrupters
CSA File 700103
CE mark – Declaration of Conformity
Page 13
PUB 51079