Disconnection - SHOWTEC FX Shot Manual

The FX Shot only works with approved electric confetti and streamer cannons.
The FX Shot is not suitable for other than the 40 and 80mm cannons shown below.
Metallic products have a slightly heavier weight and will therefore achieve greater output.
The electric cannons contain pressure holders so the confetti / streamers blows the confetti away with a
The FX Shot may only be operated by adult and competent persons.
The FX Shot may only be operated when all components are completely and correctly installed /
When the FX Shot is connected to the mains power supply, the connected electrical cannon will shoot.
Make sure you only shoot the FX Shot when no persons, animals or objects are in the path of the cannon.
SETUP 1
SETUP 2

Disconnection

1) Disconnect the FX Shot from the power, make sure it is no longer connected to a voltage source.
2) Remove the IEC cable.
3) Remove the cannon from the FX Shot.
All pre-filled cannons are destined to be used only once !!!
lot of pressure. Always keep a free shooting range.
Use caution when operating the FX Shot:
connected.
11
50335 Showmaster 24
Or use a 50317
50363 DJ-Switch 6
SB-16