Preparations; Installing The Ailerons - Phoenix Model BERGFALKE Instruction Manual

INSTRUCTION MANUAL

PREPARATIONS

Use a covering iron with a covering sock on
high heat to tighten the covering if necessary.
Apply pressure over
thoroughly bond the covering to the wood.
Main Wing
u
Aileron
0
fril
Apply instant glue (CA glue, super glue).
Assemble left and right
sides the same way
sheeted areas to
'
,.--------. u
'
@
--�

INSTALLING THE AILERONS

1. Test fit the ailerons to the wing with the hinges.
If the hinges don't remain centered, stick a pin
through the middle of the hinge to hold it in
position.
2. Apply six drops of thin CA to the top and bottom
of each hinge. Do not use CA accelerator. After
the CA has fully hardened, test the hinges by
pulling on the aileron.
u
► Make certain the hinges are adequately secured with glue. If
they come loose in flight accidents may result.
8
Secure nylon hinges with instant glue, being careful
not to glue the wing and airleron together.
©
Align the center line of main wing with aileron.
5
BERG FALKE
u