Counting - Amrotec MiB-9 Operator's Manual

Counting

In AUTO mode, the machine starts counting banknotes automatically if it detects the existence of any bill in the hopper.
In MANUAL mode, the machine counts banknotes only if banknotes are placed into the hopper and START key is
pressed. While counting, the machine displays the number of the banknotes on LCD screen and it stops working if it
meets any of the conditions describe at below;
No banknotes in the hopper
-
Stacker pocket is full.
-
Reject pocket is full.
-
The number of banknotes counted is the same as the pre-set batch number set in BATCH mode.
-
Errors have occurred.
-
If an error occurs during counting operation and the machine stops, an error message will display. To clear the error,
press "C" key. The machine will try to clear the error automatically, but if it fails to clear the error or in case of a machine
jam or some other mechanical errors, carefully open the front or rear cover to remove the jammed banknote(s) and close
the cover correctly. Then press the CLEAR key again to clear error message.
Press START/STOP/ENTER button to stop operation while the machine is counting.
14
STOP during OPERATION
To restart, press CLEAR button.