Setup Of Servo Program - JUKI AMB-289 Engineer's Manual

(4) Setup of servo program

Perform the work by the procedure below when rewriting the servo program in the same way of "(3) Setup of
main program".
1. When main program matches with servo program
Perform the work by the procedure below when making the servo program version-up by using the smart media
card.
1) First, turn ON the power. Normally, the sewing ready screen is displayed.
2) Insert the smart media card into the operation panel.
3) Perform operation by the procedure displayed in the screen below.
EPD
Data edit screen
1) Press key
Communication screen 1
2) Press key .
3) Press key .
EPD
Data selection screen
3) Press key
4) Press key
d
– 99 –
for three seconds.
EPD
.
.