Setting Up the Polycom Instructor FS HDX
Configure and Use the System
Press the
button on the Sampo remote
AV
1
control that you received with the
flat-panel display, and then select
This will enable you to complete the HDX setup
wizard using the Polycom remote control.
Note
In the HDX setup wizard, make sure
you set the Monitor 1 setting to DVI
1280x720 60Hz.
For information about using the Polycom remote
control, refer to the User's Guide for Polycom HDX
Systems. For information about the setup wizard,
refer to the Administrator's Guide for Polycom HDX
Systems.
Press the
button on the Sampo remote.
AV
2
Calibrate the touch screen for the SMART
Board interactive whiteboard.
For information about how to calibrate the
SMART Board, refer to the documentation that
you received with the SMART Board interactive
whiteboard.
Configure the HDX 9002 system by following
3
the instructions in the Administrator's Guide for
Polycom HDX Systems.
26
HDMI.
product pic here
Administrator's Guide
for Polycom HDX Systems
Version 1.0.1
December 2006 Edition
3725-23977-002/A
Version 1.0.1