Manual Changes - Agilent Technologies 4284A Service Manual

A-1 . I NTRODUCT I O N
This appendix contains t h e information req uired to adapt this manual t o earlier versions or
configurations o f t h e H P 4284A than the current printing date of this manual. T h e informa­
tion in this manual applies d irectly to HP 4284A Precision LCR M eters whose serial n umber
prefix is listed on the title page of this manual.
A�. MANUAL CHANGES
To adapt this manual to your HP 4284A, refer to Tables A and B, and make all of the
manual changes listed opposite your instrument's serial number and ROM-based firm­
ware' s version.
Instruments manufactured after the printing of this m anual may be different than those
docu mented in this manual . Later instrument versions will be documented in a manual
changes supplement that will accom pany the man ual shipped with that instrument. If
your instrument serial n umber is not listed on the title page of this manual o r in Table A, it
may be d ocu mented in a yellow MANUAL CHANGES supplement.
Refer to the descriptio n of the *IDN? command in SECTION 8 , COMMAND REFERENCE,
OP ERATION MANUAL for confirmation of the ROM-based firmware' s version. For addi­
tional information o n serial number coverage , refer to S ECTION 1 .
Table A. Manual Changes by Serial N umber
Serial Prefix
or N umber
Table B. Manual Changes by Firmware' s Version
Version
APPENDIX A
MANUAL CHAN GES
Make Manual Changes
There are no earlier configurations than the printing
date of this manual.
Make Manual Changes
There are no earlier versions than the printing date of
this manual.
A-1