Hach Polymetron 9610sc SiO2 Installation Manual page 31

Option Description
MANAGE DEVICES Installs or removes input modules. Refer to
devices
INSTRUMENT Shows the analyzer information. Refer to
INFORMATION instrument information
CALCULATION Set up variables, parameters, units and formulas for
the analyzer. Refer to
on page 12.
SETUP OUTPUTS Selects and configures the 4–20 mA setup, the relay
setup and the error hold mode. Refer to
the outputs
SETUP NETWORK Shows only if a network card is installed. The
(conditional) network card support is for Modbus, Profibus and
HART.
SECURITY SETUP Enables or disables the pass code (default =
HACH55).
AIR PURGE Enables the air purge when an outside air purge is
used on the analyzer (default = off). To use this
feature, make sure that the fan filter plug is installed.
Refer to the documentation that is supplied with the
air purge kit.
RESET DEFAULTS Sets the configuration to the factory defaults.
Manage devices
Install or remove input modules.
1. Select MANAGE DEVICES.
2. Select an option.
Option Description
SCAN FOR The system shows the connected devices.
DEVICES Note: If no device is connected, the system returns to
the main measurement screen.
DELETE DEVICE Removes the device when the device is no longer
connected.
12 English
Manage
on page 12 for more information.
View
on page 17.
Set up the calculation
Configure
on page 12 for more information.
Set up the calculation
Set up variables, parameters, units and formulas for the analyzer.
1. Select CALCULATION.
2. Select an option.
Option Description
SET VARIABLE X Selects the sensor referring to the variable X.
SET PARAMETER X Selects the parameter referring to the variable X.
SET VARIABLE Y Selects the sensor referring to the variable Y.
SET PARAMETER Y Selects the parameter referring to the variable Y.
SET FORMULA Selects the calculation formula to complete. Options:
None, X-Y, X+Y, X/Y, [X/Y]%, [X+Y]/2, X*Y, [X-Y]%/X
DISPLAY FORMAT Selects the number of decimal places shown in a
calculation result. Options: Auto, XXXXX, XXXX.X,
XXX.XX, XX.XXX, X.XXXX
SET UNITS Enters the unit name (maximum of 5 characters).
SET PARAMETER Enters the measurement name (maximum of
5 characters).
Configure the outputs
4–20 mA module setup
1. Select SETUP SYSTEM>SETUP OUTPUTS>4–20mA SETUP.
2. Select the OUTPUT.
3. Select an option.
Option Description
ACTIVATION The menu list items change with the selected function.
Refer to 4–20 mA activation options
more information.
on page 13 for